Headboard Redo

Here is a picture journal of a king sized headboard redo.

Ugly fabric, great shape. We marked the edge of the border with a marker then pulled it off with hammers. Keep the upholstery nails (not staples) that attached the boarder piece, save them for when we reattached the boarder.

The Marker mark is red- we put it there to make sure the staples went past that point.

We laid the upholstery weight fabric backed with batting over the  center, then stapled along the outside edge of the marker guide we drew. then, cut away the extra fabric.

We wrapped extra batting around the boarder because the fabric was gathered and we were too  smart/lazy to remove it... I wish I would have got a picture of how truly hideous the fabric was. we just wrapped it and put a few staples in to keep it in place.

Cuteness.

more cuteness

we stapled the fabric only to the inner curve of the boarder piece so we could wrap the rest of the fabric around to the back side of the headboard. Lift the fabric on the boarder gently and tack the boarder to the main headboard by using the nails we saved from when we removed the boarder.

We didn't have enough fabric for one continual piece around the boarder, so we covered it with three separate piece of fabric. Then we folded the fabric under and overlapped it at the corners. Pulling it tight and stapling it to the back.

Three hours later.

It needed a little something. So we added nailhead trim. Beautiful!